How to use Switch Align Plate for W1-AT

The W1-AT uses the Switch Align Plate because it can be difficult to align the switch without a plate.

When using the Switch Align Plate, the stabilizer must not be installed.

First, use the middle plate to install the switch

Carefully turn the switch over and solder it so that it does not fall off.

 

Once the soldering is complete, use the Plier Tool to grasp the thick edge of the switch plate and break it.

Be careful not to scratch the PCB

 

 

Grasp and pull the other side of the Switch Align Plate to remove the plate.

 

Second, use the left plate to install and solder the switch and break the thick side of the switch align plate.

 

 

Pull the plate as far as possible so that it does not get caught in the switch on the right.

 

 

Cut off the part marked with a wire cutter.

Be careful not to scratch the PCB

Remove the Switch Align Plate.

 

Third, use the right plate to install and solder the switch and break the thick side of the switch align plate.

 

Pull the plate as far as possible so that it does not get caught in the switch on the left.

 

Cut off the part marked with a wire cutter.

Be careful not to scratch the PCB

Remove the Switch Align Plate.

 

 

Install the switch and stabilizers that could not be installed due to the Switch Align Plate.

Thank you for your efforts. It's done.